Emerson-process-management MICRO MOTION T-SERIES Manuel d'utilisateur télécharger pdf (Page 10)

2 Mounting

2.1 Mount the sensor

Use your common practices to minimize torque and bending load on process connections.

Tip

To reduce the risk of condensation or excessive moisture, the conduit opening should not point

upward (if possible). The conduit opening of the junction box or core processor can be rotated freely

to facilitate wiring.

Procedure

Mount the sensor in the pipeline (see Figure 2-1).

Mounting the sensorFigure 2-1:

Notes

• Do not use the sensor to support the piping.

• The sensor does not require external supports. The flanges will support the sensor in any orientation.

CAUTION!

Do not lift the sensor by the electronics or purge connections. Lifting the sensor by the

electronics or purge connections can damage the device.

Mounting

6 Micro Motion T-Series

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Emerson-process-management MICRO MOTION T-SERIES Manuel d'utilisateur Page 10